STUDY OF PLASMOCHEMICAL PROCESSING EFFECT ON THE PROPERTIES OF POLYMER FILMS BASED ON POLYVINYLCHLORIDE

Kseniya V. Volkova, Irina V. Trotsenko, Uspenskaya Mayya Valerievna, Balya Vera K, Evgeny V. Sivtsov, Evgeny V. Belukhichev

2017 , VOLUME 17, NUMBER 5 ( September-October )

ISSN 2226-1494 (print), ISSN 2500-0373 (online)

Publications

Editor-in-Chief

Nikiforov
Vladimir O.
D.Sc., Prof.

Partners

doi: 10.17586/2226-1494-2017-17-5-834-840

STUDY OF PLASMOCHEMICAL PROCESSING EFFECT ON THE PROPERTIES OF POLYMER FILMS BASED ON POLYVINYLCHLORIDE

K. V. Volkova, I. V. Trotsenko, M. V. Uspenskaya, V. K. Balya, E. V. Sivtsov, E. V. Belukhichev

Read the full article

Article in Russian

For citation: Volkova K.V., Trotsenko I.V., Uspenskaya M.V., Balya V.K., Sivtsov E.V., Belukhichev E.V. Study of plasmochemical processing effect on the properties of polymer films based on polyvinylchloride. Scientific and Technical Journal of Information Technologies, Mechanics and Optics, 2017, vol. 17, no. 5, pp. 834–840 (in Russian). doi: 10.17586/2226-1494-2017-17-5-834-840

Abstract

Subject of Research.The paper deals with characteristics study of polymer composites based on commercially available polyvinyl chloride and biopolymer filler pectin in various weight ratios (1.5 and 10 mass%) for the usage as biodegradable packaging. Method. Biopolymer composite films were obtained by rolling at the temperature of 165-170 ℃and pre-mixing of all composition components with a paddle stirrer at a stirring speed of 6000 rpm for four minutes. The introduction of natural materials into the polymer matrix facilitates the decomposition of plastics during disposal, and the processing of composite polymeric materials for five and ten minutes by low-temperature plasma in argon: oxygen modifies the surface of the material, ensuring access of microorganisms for biodegradation. Samples of composites were studied by the methods of infrared Fourier spectroscopy and optical microscopy, depending on the content of the filler and etching time of the samples. Main Results. The effect of plasma-chemical treatment on the surface of polymeric composites has been experimentally proved; an increase in roughness, craters and other discontinuities may be explained by structural changes confirmed by infrared spectra. It is shown that composites containing 1% by weight of pectin are subjected to the greatest degree of material oxidation. Practical Relevance. The resulting biopolymer composites can be used as a package that decomposes during disposal and does not harm the environment. The introduction of a biodegradable component, natural polysaccharide of pectin, in small amounts does not change the chemical structure of the polymer material. Plasma-chemical treatment can be used as a method for surface treatment of industrial polymer materials before disposal.

Keywords: PVC, polymer film, pectin, biodegradation, plasma-chemical processing

References

1. Focke W.W., MuiamboH., Mhike W., Kruger H.J., Ofosu O.Flexible PVCflame retarded with expandable graphite. Polymer Degradation and Stability,2014,vol. 100,no.1,pp. 63–69.doi: 10.1016/j.polymdegradstab.2013.12.024

2. Gotlib E.M., Nguyen A., Miloslavskiy D.G., Sadykova D.F. Ecological aspects of using derivatives of vegetable oils in polymer chemistry. Vestnik KSTU, 2017, vol. 20, no. 4, pp. 17–20.(In Russian)

3. Simonov-Emelianov I.D., Markov A.V., Prokopov N.I., Anshin V.S., Petrov O.O., Munkin N.I. Effect of self-heating during processing on the thermal and light stability of DYED rigid and plasticized PVС. Plasticheskie Massy, 2013, no. 2, pp. 51–54.(In Russian)

4. Yu J., Sun L., Ma C., Qiao Y., Yao H. Thermal degradation of PVC: a review. Waste Management,2016,vol. 48,pp.
300–314.doi: 10.1016/j.wasman.2015.11.041

5. Antsiperov V.E., Bugaev A.S., Zabrosaev I.V. A new PVC/SPB detection method: based on analytical spectra technique.Proc. 2016 Int. Conf.on Bioinformatics and Systems Biology. Allahabad, India, 2016.doi: 10.1109/BSB.2016.7552150

6. Lavrov N.A., Kolert K., Ksenofontov V.G., Lavrova T.V., Belukhichev E.V. On destruction mechanism of polyvinyl chloride. Izvestiya SPbGTI(TU), 2012, no. 16, pp. 31–35.(In Russian)

7. Subbotin E.V., Shcherbinin A.G., Ershov S.V. Thermal analysis of PVC plastic compound. Scientific and Technical Volga region Bulletin, 2013, no. 5, pp. 59–62. (In Russian)

8. Sedyh V.A., Zhuchkov A.V. Technical properties of packaging PVC films. Proceedings of the Voronezh State University of Engineering Technologies, 2013, no. 2, pp. 141–146. (In Russian)

9. Erenkov O.Yu., Petrova S.I., Bogachev A.P., Cirkon V.N. An innovative way of recycling PVC. Uchenye Zametki TOGU, 2016, vol. 7, no. 4, pp. 442–444.(In Russian)

10. Pulngern T., Chitsamran T., Chucheepsakul S., Rosarpitak V., Patcharaphun S., Sombatsompop N. Effect of temperature on mechanical properties and creep responses for wood/PVC composites. Construction and Building Materials,2016,vol. 111,pp. 191–198. doi: 10.1016/j.conbuildmat.2016.02.051

11. Denisyuk I.Yu., Pozdnyakova S.A., Koryakina I.G., Uspenskaya M.V., Volkova K.V.Polymer photodegradation initiated by ZnOnanoparticles. Optics and Spectroscopy,2016,vol. 121,no.5,pp. 778–781.doi: 10.1134/s0030400x16110096

12. Aminova G.F., Gabitov A.I., Maskova A.R., Yagafarova G.G., Rolnik L.Z., Klyavlin M.S. New composite PVC-material for finishing purposes, plasticized by butoxyalkylphenoxyalkyl phthalates. Oil and Gas Business, 2013, no. 5, pp. 353–362.

13. Sadiyeva N.F., Aliyeva A.Z., Zeynalov E.B., Iskenderova S.A., Nuriyev L.H., Agayev B.K. New composite materials based on PVC. Plasticheskie Massy, 2014, no. 9-10, pp.
13–15.(In Russian)

14. Ebnalwaled A.A., Thabet A. Controlling the optical constants of pvc nanocomposite films for optoelectronic applications. Synthetic Metals,2016,vol. 220,pp. 374–383.doi: 10.1016/j.synthmet.2016.07.006

15. Grigoryeva O., Fainleib A., Stepanenko L., Sergeeva L., Pissis P.Recycling of pvc/pu waste and reuse in pvc formulations: structure-property relationship. Polymer Engineering and Science,2005,vol. 45,no. 6, pp. 801–808. doi: 10.1002/pen.20343

16. Zhazaeva E.M., Tkhakakhov R.B., Oshkhunov M.M. Strength and destruction of heat-treated mixtures of polymers based on PVC and SKN. Plasticheskie Massy, 2013, no. 9, pp. 54–57.(In Russian)

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License