DESIGN METHOD OF THE THREE-DIMENSIONAL PRINTED-BOARD ASSEMBLY

O. V. Kuznetsova, E. B. Romanova


Read the full article  ';

Abstract

Design method of the three-dimensional printed-board assembly by solid form-factors is suggested. The
conclusion is done about increasing possibility of CAD efficiency for printed-board assemblies by layout speed growth and computing optimization.


Keywords: printed circuit board design, three-dimensional modeling, CAD, solid-state modeling, layout

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License
Copyright 2001-2024 ©
Scientific and Technical Journal
of Information Technologies, Mechanics and Optics.
All rights reserved.

Яндекс.Метрика